Flashlights

Light timer garage for automatic garage doors.

Powered from the garage lights after the garage light contact activation of the door operator's manoeuvre box, which can adjust the time of the lights will remain on.

Timed garage light card Clemsa TG2 for old CLAS manoeuvres.

Impulse garage light card Clemsa TG3 for old CLAS manoeuvres.

Lamps and lighting fittings Beninca "LAMPY" 230V with integrated antenna.

Yellow flashing lamp Beninca "IRI.LAMP-Y' multi voltage of 20÷255 Vac/dc with integrated antenna.

LED signalling lamp V2 BLINKO multi voltage from 24 to 230 V.

Flashing light without built-in antenna for motors with 24 V power supply.

The flashing signal light for automatic cancellation, RADIUS LED of BFT, 24 V without built-in receiving antenna. Thanks to LED technology, energy consumption is reduced by approximately 80% compared to models with traditional incandescent bulbs, while the product life is extended. Possibility to install on a surface (such as a pillar or column) or on the wall using the special accessory. Grade of protection IP44.

Antennas tuned for flashing lamps CAME KLED. What. Working frequency 433 MHz suitable for working with TOP-432EE transmitters

Wall support for flashing lamp CAME I KNOW.

Suitable for outdoor use (outdoor and waterproof).

Lamps and lighting fittings CAME KLED for automatic door signalling, fed at 120/230 Vac.

Suitable for outdoor use (outdoor and waterproof).

AURA is an LED flashlight available with power supply: 230V and 24V. In both versions the visual signaller integrates into the circuit an antenna and a 433MHz receiver. The length of the cable is 5m.

Universal LED flashing lamp, compatible with all types of power plants. Power supply at 230Vac / 24Vac/dc / 12Vac/dc

Automation of capacity control is one of the preventive measures that have been put in place to curb the spread of the Covid-19 epidemic.

ControlTradeGate® allows management and control of any glass door, automation or access system, being an integral system and adapted to the various new or existing installations.

It 's the only device on the market that 's "plug and play"I'm not going anywhere. In a very short time, and without the need for special knowledge, anyone will be able to perform an installation of this device, which will be used to manage, accesses, capacity and doors ...

Multi-voltage led signalling lamp V2 I MEAN, WE...

With this electronic card you can light up your garage by opening the door to the entrance or exit.

It is very easily placed on the control board and can be programmed to be turned on by pulse or timer.

The TSM 2 U traffic light control module is a device for regulating the passage of vehicles through traffic lights.

It is indicated for the passage control in garages with entrance and exit by the same door, two-way parking ramps, accesses to businesses by two-way barriers and all situations where it is necessary to regulate the passage of vehicles through a single point through traffic lights.

Intermittent light and acoustic pilot, powered at 230V, ideal for sound signalling and warning of the presence of a vehicle when entering or leaving the garage.

LED signalling lamp with fixed or flashing light. What. In the case of vehicles with a maximum mass not exceeding 2000 kg:. THIS IS IP 54. 90 x 190 x 75 mm

LED flashing light in version 90-240 Vac and 12-36 Vdc with an integrated 433,92 MHz antenna.

Universal LED flashing lamp, compatible with all types of power plants. Power supply at 230Vac / 24Vac/dc / 12Vac/dc

Traffic light receiver card for garage manoeuvres Erreka.

Lamps and lighting fittings Erreka LUMI multi voltage with antenna 433 MHz, used to warn of movement of motorised automatic doors.