PUJOL VARIOPASS station with 433.92 MHz access control, capacity 2,000 codes. Two channels expandable up to 5.

CHARACTERISTICS

• Access Control Center for 2000 users, activation of relays with radio transmitters or with keys or proximity cards.

• Connection of up to 4 proximity readers in parallel.

• It has 2 relays on the base plate for 2 accesses, easily expandable with 3 more relays, the fifth relay can be used as an alarm output.

• All relays can be programmed as normal (impulsional or bistable)

• Connection to a serial computer to monitor inputs, outputs, save and recall memory.

• Battery connection, without card, to ensure that the equipment works with mains power failure

• 10 Amp output base plate relays, suitable for direct connection of an electric lock.

• Possibility of connecting an anti-passer card, and time control to control inputs and outputs.

• Easy programming of new users by means of keyboard and LCD display of 2 lines of 16 characters.

• Possibility to deregister issuers individually.

• Possibility to make reservations of controls.

• Possibility of programming transmitters or keys in zonal mode, which can only access certain relays.

• Possibility to connect an extension of inputs/outputs to increase the number of accesses.

INSTALLATION

• Before installing the control unit, make sure that the supply voltage is switched off.

• In case of connecting 12 Volt battery, make sure to connect well the polarity terminal 3 positive, and 4 negative.

• The Control Unit only works with VarioCode transmitters and proximity keys. (With P215 emitters, ' * ' is indicated on the display).

Password Entry

Pressing the 'PROG' button will give you a long audible signal and 0000 will appear as the access code on the display.

Above the active digit that we can move with the 'increase' and 'decrease' keys appears the symbol *.

At the top right of the display is the number of attempts to access the password that we have.

We have 3 attempts in 30 seconds, if we fail the control unit is blocked for 2 minutes.

We move the passcode until we have the correct password and then activate the 'Enter' key.

If the access code is correct, the programming phase is entered and the memory position 1 is displayed.

Code Programming

With the 'increment', 'decrement' and 'fast increment' keys we access the memory position from 1 to 2000 that we want.

To register a transmitter we place ourselves in the free position we want to occupy and then we press the control, when the transmitter is recorded it is indicated by an audible beep, if the I3 switch is OFF the recorded code is displayed, if I3 is ON it goes to the next free memory position. To give a low emitter, place yourself in the position and press the 'C' key.

To exit programming, press the 'FUN' key.

The ER 3 message indicates that the position we want to program is occupied.

The ER 4 message indicates that the sender we want to program is registered in another position.

If we want to re-enter the program and less than 5 minutes have passed since the last programming, the control panel does not ask us for the password.

SPECIFICATIONS

• Power supply: 220Vac
• Current Consumption at 12V: 60mA Unlit 160mA Illuminated Display
• Output Relays: 2 x 10A
• Relay Expansion: 3 x 1 A
• Panic Alarm: Optional Relay
• Optional Power Battery: 12 Volts
• Working Frequency: 433.92Mhz
• Receiver Sensitivity: Better than 104dbm
• Standard: ETS300 220
• Access Control: Maximum 4 readers
• Computer Access: Yes RS232
• Antipassback: Optional
• Time Control: Optional
• Expansion of inputs/outputs: Optional
• Temperature Job: 0 to 70ºC

MANUAL

Instruction manual PUJOL VARIOPASS