Safety Accessories

Security card EMFA "BSC-SC' to incorporate 8,2 KΩ safety-belt boundary for dead-end manoeuvring frames.

Mechanical safety belt EMFA 70 mm by micro-switches, with cable voltage monitoring and sensitivity regulation.

It can be used for swinging or tilting doors, sensitive over the entire path of the band (including ends).

Waterproof box button with OPEN, SHUT, and emergency STOP buttons.

Manufacture from materials of any heading CAME DLX synchronized infrared beams up to 30m.

Pair of optical equipment Nice FT210 adjustable at 210o for sensitive edges with wireless transmitter and mobile mounting.

LED signalling lamp V2 BLINKO multi voltage from 24 to 230 V.

Passive band Erreka rubber bumper profile designed for automatic tilting, sliding or swinging doors.

Mechanical safety belts against crushing for automatic doors or electromechanical barriers.

The LB mechanical belt is a mandatory safety system to comply with the regulations in force which protects us from being crushed by an automatic door or barrier, can be used in tilting, sectional doors, blinds and electromechanical barriers.

Metallic protector Erreka LPRER4 for safety mirrors of photocells.

Industrial steerable photocell Erreka KLFRX traceable transmitter-receiver with obstacle detection and wide range.

Laser sensor or Barrier scanner Clemsa XGUARD for motion and presence detection.

Industrial radars Clemsa with opening and opening sensors with presence detection.

Infrared sensor FAAC XPB-ON presence and movement, with active infrared technology with background suppression.

The MF2020 is a column photocell developed to safeguard all types of industrial doors (sectional and fast doors) up to a maximum width of 10 metres.

The sender and receiver create a infrared grating it offers protection up to eight feet high.

When the infrared beams are interrupted, a signal is sent to the control room. After the holding area is clear, a new signal is sent to the control to indicate that the area is clear.

Flashing light without built-in antenna for motors with 24 V power supply.

The flashing signal light for automatic cancellation, RADIUS LED of BFT, 24 V without built-in receiving antenna. Thanks to LED technology, energy consumption is reduced by approximately 80% compared to models with traditional incandescent bulbs, while the product life is extended. Possibility to install on a surface (such as a pillar or column) or on the wall using the special accessory. Grade of protection IP44.

Lamps and lighting fittings CAME KLED for automatic door signalling, fed at 120/230 Vac.

Suitable for outdoor use (outdoor and waterproof).

Emergency fence (STOP) with watertight case to stop the automatic in case of emergency.

Of a thickness of V2 which prevents pedestrians from catching their fingers on the hinge edge.

The MX14 and MR14 devices are a solution developed for the prevention of automated vehicle accidents, as required by EN 12978.

Pair of safety photocells Beninca Pupil oriented 180o. Ability to synchronize up to 4 pairs. Power supply 24 Vdc.

Easy adjustment by LED indicating correct alignment.

Of a thickness of Clemsa model BAPZ, which prevents pedestrians from catching their fingers on the hinge edge.

Compact radar FAAC XM100 ONE one-way microwave.

The smallest opening radar for doors.

Sensor FAAC XBFA of movement and presence over infrared radiation.

The ideal security for automatic curtain doors. Aperture and security in one sensor.

Sensor FAAC XDT1 with dual technology for movement and presence.

Aperture and security in one sensor. Safety control according to EN 16005.

Sensor FAAC XV1 with dual technology for movement and presence.

Aperture and security in one sensor. Safety control according to EN 16005

Sensor FAAC XDT3 with dual technology for movement and presence for evacuation routes.

Aperture and security in one sensor. Safety control according to EN 16005.

The FP200 finger guard of a thickness not exceeding 6 mm prevents pedestrians from catching their fingers on the hinge edge.

Elegant design that doesn't interfere with the aesthetics of the door.

Versions complying with EN16005 are available.

Manufacture from materials of any heading Erreka Controlled industrial LFTIND with anti-vandal obstacle detection. What. Detection distance up to 60m indoors and up to 40m outdoors.

AURA is an LED flashlight available with power supply: 230V and 24V. In both versions the visual signaller integrates into the circuit an antenna and a 433MHz receiver. The length of the cable is 5m.

The DEA 105 / no They are a couple of Photocells to embed, designed to provide security and discrete integration in automatic door installations, garages and residential or industrial accesses.

Thanks to its recessed format, these photocells allow a more aesthetic and protected installation, being perfectly integrated into pillars, walls or access structures.

Pair of photocells CAME DELTA-E 12 - 24 V AC - DC surface, complete with box. Range 20 meters .

" THIS MODEL HAS BEEN REPLACED BY THE NEW PHOTOCELL FOR THE PURPOSES OF THIS REGULATION, THE FOLLOWING DEFINITIONS SHALL APPLY: FULLY COMPATIBLE "

Pair of photocells CAME TO SAY with a surface of 12-24 V AC-DC.

Universal LED flashing lamp, compatible with all types of power plants. Power supply at 230Vac / 24Vac/dc / 12Vac/dc

Line-x / l is a couple of PHOTOCELLES ASTAILED AND SYNRONE, designed to offer maximum safety and flexibility in automatic door installations, both residential and industrial.

Thanks to its adjustable system, it allows to accurately adjust the detection angle, facilitating installation in complex areas or where conventional photocells can not be properly aligned.

Line-x is a couple of Compact and synchronizable photocells, designed to improve safety at automatic doors, garages and residential or industrial accesses.

Thanks to its reduced size and its elegant design, these photocells are ideal for installations where discretion required without renouncing reliability.

Sensors are the electronic devices used to activate the door opening as well as to ensure the safety of users.

Detection device based on microwave technology for opening automation, its great qualities are the great range of action, signal stability and precision in the detection of movements within the maneuvering area of the automation. Possibility to adjust numerous parameters by remote control (optional) to suit any installation and climatic situation.

Security sensor Motorline RAP5M-PRO for automatically sliding pedestrian doors with 6 detection pointsn and installation up to 2.6 m high.

Radar Motorline Small RAP50 microwave technology ideal for glass doors and pedestrians, which can be installed up to 4 m high.

Infrared detection radar, developed to activate automatic doors at a distance of up to 3m.

Infrared radar Motorline MR30 easy to install and extremely compact, developed to activate automatic doors at a distance of up to 3m.

Microwave motion detection radar up to 3000 mm in height.

For use in the manufacture of motor vehicles, designed to offer a high level of flexibility of installation thanks to their compact size, the possibility of adjusting the head 90° horizontally, left and right (180° total), and a wide input range of power supply 12-33 V AC and 15-35 V DC. What. Nominal range of 20 meters.

The radio system simplifies even complex installations, eliminating the need for wiring between the safety band and the automatic control panel.

The radio system consists of a receiver XR S 868, communicating with an emitter XT S 868, to which one or two 8,2 Kohm resistive safety bands or auxiliary devices may be connected.

" The safety belts on the product accessories are fully compatible "

Automation of capacity control is one of the preventive measures that have been put in place to curb the spread of the Covid-19 epidemic.

ControlTradeGate® allows management and control of any glass door, automation or access system, being an integral system and adapted to the various new or existing installations.

It 's the only device on the market that 's "plug and play"I'm not going anywhere. In a very short time, and without the need for special knowledge, anyone will be able to perform an installation of this device, which will be used to manage, accesses, capacity and doors ...

Magnetic contact Clemsa CM1 for pedestrian doors. What. Medium power. In the case of vehicles of categories M1 and N2. Surface installation. 6 terminals. High power.

Manufacture from materials of any heading Clemsa F35 mirror fed to 12/24V with retro-reflector up to 12 metres and IP66 protection.

Pair of self-aligning photocells BFT GIVE ME A 15, 24Vac power and 30m range.