Electronic plate Beninca "CP.J3-SW' for sectional motors of the 24 V JM series.

CONTROL CENTRE CP.J3-SW

• Parameter regulation and operating logic by trimmers, dip-switches and keys
• Built-in radio receiver 433,92 MHz 64 codes and ARC radio coding
• Fixed terminals
• Automatic, semi-automatic and man-present operating logic
• Step by step, stop, photocell
• Integrated LED courtesy light
• Self-adjustment of operating parameters
• Electronic torque adjustment with automatic calculation for each running point (STC SYSTEM)
• Electronic settings separate from opening and closing speeds
• Anti-crushing safety with amperometric detection and coding management
• Electronic regulation of the strap residual stress at the end of the manoeuvre at 4 levels
• Controlled deceleration
• ESA SYSTEM + integrated for energy saving
• Possibility of setting parameters and managing transmitters with the Advantouch system
• Pre-set for connecting the battery charger SW.CB (optional)
• Pre-set for KNX connection through X.BE card (optional)
• Prepared to manage, configure, diagnose and update firmware through the BeUP application, using the PRO.UP accessory