Magnetic burial spiral for vehicle detectors. what. available in two versions:

• Spire to bury, cable to 2x1, 20 m in length.
• Spire to bury, cable to 3x2, 20 m in length.

It's compatible with all brands of presence detectors.

The spire of 2x1 is ideal for the detection of passenger cars and motorcycles, but the breath of 3x2 it is designed to detect larger metal masses for example, trucks.

MODE OF USE

The magnetic spiral can be used for a metal mass detection system. It can be used as a safety system to prevent vehicles from getting trapped under a door or barrier, as well as to prevent pedestrians from remotely opening garage doors intended for vehicles by preventing access if the detector has not detected a metal mass in the corresponding area.

It is installed just in front of the door (optionally both at the entrance and exit) and by means of a magnetic induction circuit is able to detect the presence of a vehicle. It is compatible with any mass detector system, at the bottom of the page we will offer some options.

RECOMMENDATIONS

Installation of the spire 2x1 shall be buried at a depth of approximately 5 m in a space of 2x1 the detection area to the magnetic detector shall not normally exceed 20 metres.

The spire of 3x1 shall be installed in the same way but with a detection area of 3x2 in the case of vehicles with a maximum design speed of more than 100 km/h, it is recommended to use a speedometer.

It is important to note that in the detection zone there can be no metallic elements (such as arquettes) at least half a meter from our magnetic loop.