List of products by brand Clemsa

Outer receiver Clemsa MasterCode RV44, frequency 433.92 MHz 4 channel 230Vac or 12/24V ac/dc power supply.

Memory Clemsa TM400 MUTANCODE of 400 users.

Compatible with frames and receivers Clemsa from the MUTANCODE series.

Wired receiver Clemsa Mastercode "RMV 2U" 12/24V 433 MHz with two channels.

The universal receiver 'RMV 2U' is fed to 12/24V ac/dc to be able to be connected in any manoeuvring frame which has an alternate button output.

Outdoor antenna designed for installations with reception problems due to obstacles such as metal surfaces, radio shadow zones or long distances.

The external antenna RET 400 needs to be connected a decoder card or Access Control, replacing these to the affected receivers if necessary. This connection is carried out using only two wires, so the installation is simple by taking advantage of cables from old installations of other equipment

Plug-in receiver card Clemsa "RNE248" frequency 433 MHz & 868 MHz, 2 channels with memory up 400 users.

The receiver can operate independently at 433 MHz or 868 MHz and is compatible with Mutan and Mutan-II broadcasters.

Adapter for new cards Clemsa Master code RMV and mutant code RNE248.

Other, of circular cross-section Clemsa Mastercode "RMV 2" 433 MHz with two channels.

The receiving card 'RMV 2" connects directly to manoeuvring frames Clemsa have at their disposal connection 4 pins which allows us to connect directly to the circuit board without the need for wiring.

Plug-in receiver card Clemsa Mutated for 400 users, of 2 channels at 433,92 MHz and 868 MHz on the same receiver. Compatible with the Mutan and Mutan-II emitters.

Hydraulic oil Clemsa/FAAC in a 2-litre bottle.

CN20 Nervous Caps for Engine Clemsa AB10BC (6 units)

Plastic garage control board Clemsa Mutancode Mini in grey.

Spare Clemsa AA300 / AA400 small pieces Mistral Sirocco.

Unlock lock with Key Clemsa for AC Motors 424 N, AC 824 N, AC 562 N and AC 862 N.

Unlocking motor batten Clemsa AA300/AA400 with light bulb and keys.

The Unlocking Handle Clemsa It is the original spare part designed for engines Ac562n and Ac862n. It allows to perform the manual opening of the automation in case of electrical failure or maintenance.

Software engineer Clemsa PT8 for facility management by Software SW8 for the management of Mutan-II and MutanCode systems via Smartphone (Android).

Guide to Strap for Secondary Motor Clemsa AS60/AS100 and FAAC D600/D1000

Iron Guide with Correa for Secondary motor Clemsa AS60, AS120, and FAAC D600, D1000, which ensure smooth, silent and efficient operation of your garage door. Manufactured with high resistance materials, this guide offers a precise transmission and a long service life, ensuring the optimal performance of automatisms Clemsa and FAAC.

Full race finish (box with electronics) for retractable motor Clemsa AR2581.

Electric brake Clemsa EF81 for rolling stock AR2581, allows us to block the blinds once closed. Emergency unlocking can be done with the handle on the mechanism.

Electric lock ERREKA LV9083 VIRO with adjustable input of 50-60-70-80 mm. It's got an internal pusher.It's a long shot. Horizontal or vertical mounting.

Electrical lock ERREKA LV9083 VIRO with outside pump, a width of not more than 50 mm. This is a 60mm Long Gun. Horizontal or vertical mounting.

For use in the manufacture of motor vehicles Clemsa Content of the Annex to the Directive:.

With front end of standard dimensions 74x74 mm .

Includes 2 LK10 magnetic keys.

LED signalling lamp with fixed or flashing light. What. In the case of vehicles with a maximum mass not exceeding 2000 kg:. THIS IS IP 54. 90 x 190 x 75 mm

Machinery for making pulp of fibrous cellulosic material Clemsa, to detect vehicles (cars or motorcycles) when that vehicle passes over the door, it reverses the maneuver just as if we were passing in front of a photocell. A magnetic loop is also usually installed to prevent an owner from opening the door to enter on foot, therefore the door would only open if the magnetic loop detects a vehicle in the area where the winding is installed (usually in the buried ground).

We introduced a new concept of wireless vehicle detection. What. The system e-Loop replaces traditional wired inductive loops, saving time and money it also increases reliability.

Installation in 3 easy steps

1. Encode the e-Loop
2. Fix the e-Loop to the driveway
3. Calibrate the e-Loop... and it'll be up and running in less than 15 minutes

It saves many hours of installation time compared to wired loop systems.

LED traffic light Clemsa two red and green lights or amber with a 120mm lens diameter of 25 LEDs. It is ideal for signalling the passage of vehicles or people.

Emergency battery kits Clemsa and FAAC to manoeuvre in the event of a power failure.

The maximum manoeuvres shall depend on the state of charge of the batteries and the consumption of the automatic system.

Magnetic contact lock Clemsa CK20 coded for of a kind used in motor vehicles.

It shall be so designed and constructed as to conform to the requirements of this Regulation.

KIT engines Clemsa AA30 230 V electromechanical two-bladed swing doors for a maximum length of 3m by sheet. What. The AA30 model is ideal for automating residential doors for non-intensive use.

Electromechanical operator Clemsa AS60 (600N) or AS120 (1000N) for sectional doors up to 15m2 with built-in frame. Optimized installation times thanks to its patented three-step assembly. Courtesy light built in.

The KIT consists of a 230Vac electromechanical actuator with built-in box, RNE248U receiver and 2 NT2S emitters at 433 MHz.

The guide can be chosen at the choice of the customer according to their needs in our deployable.

Programmable control panel. Rolling and sliding actuators 230 V or 400 V. Max. 1500 W.

Issuer Clemsa NT1 health care two-channel, unmatched Rollingcode 433.92 MHz system with a sleek and minimalist design.

Motor gearbox FAAC D1000 / GENIUS ZODIAC 100 / CLEMSA AS60-120

Motor gearbox FAAC D600.

Control panel Clemsa Class 30.1 for the actuation of 24Vdc sectional roof doors. What. Residential use. This is a manual/automatic/semi-automatic.

Garage control of the CLEMSA brand, model MASTERcode MV12 two green buttons. The frequency of this remote is 433.92 MHz and coding is done by 8 switch system.

Basic Control Panel Clemsa CLAS10 for tilting doors. What. Residential use 230V. Maximum power 750W. Programmable opening and closing time from 6’’ to 70’’.

KIT engine Clemsa "AB10BC' electromechanical 230V for residential counterweighted tilting doors up to 10m2.

The actuator has the manoeuvre chart CLAS107 incorporated, irreversible locking system with mechanical locking so no locks are required. The manual interior unlocking allows us to actuate the door manually in case of lack of electric current.

Control panel Clemsa CLAS 107 for 230 V swing door actuators.

Other, of polymers of vinyl chloridewith their corresponding housings for residential or industrial sliding motors.

The Control Panel Clemsa CLASS 5 is designed to govern automatic doors of intensive use, sliding, tilting and folding type with 1 and 2 blades, with single and three-phase drives of 230 V AC or 380 V AC and up to 1500 W of power.

Control panel with built-in receiver Clemsa CR81 (433 MHz) or CR81.8 (868 MHz) for retractable closures.

Control panel Clemsa CLAS 60 for rolling and sliding actuators 230V. What. Maximum operating power 1000W. Programming by display.

Control panel CLAS 1 for rolling stock and 230V blinds. What. Maximum operating power 750W. Programming by pulse.

Basic Control Panel Clemsa Class 10.1 for hinged doors. What. Residential use 230V. Maximum power 750W. Programmable opening and closing time from 6’’ to 70’’.

" THE MODEL CLASS 10.1 HAS BEEN WITHDRAWN AND IS REPLACED BY THE MODEL CLASS 60 (FOR COMMUNITY SLIDING DOORS OR SLIDING DOORS), OR BY CLASS 10 (FOR RESIDENTIAL SLIDING DOORS) "

Control panel for one 230 V retractable drive. What. Power supply 230 Vac 50-60 Hz. Maximum load of the motor 1000 W. Power lock output 12 V 2A.

Control panel for two 230 V retractable actuators. What. Power supply 230 Vac 50-60 Hz. Maximum load of the motor 1000 W. Power lock output 12 V 2A.